Just had this with mine. It had just been rein flayed and E02was beeping as nothing had changed and new filter was in I gave the motor housing a gentle shake checking all the pipes were in line. Pressed on and hey presto away it went. Hope yours is as easy to fix Just had this with mine. It had just been rein flayed and E02was beeping as nothing had changed and new filter was in I gave the motor housing a gentle shake checking all the pipes were in line. Pressed on and hey presto away it went. Hope yours is as easy to fix •.

Just had this with mine. It had just been rein flayed and E02was beeping as nothing had changed and new filter was in I gave the motor housing a gentle shake checking all the pipes were in line. Pressed on and hey presto away it went.

Hope yours is as easy to fix Just had this with mine. It had just been rein flayed and E02was beeping as nothing had changed and new filter was in I gave the motor housing a gentle shake checking all the pipes were in line. Pressed on and hey presto away it went. Hope yours is as easy to fix •. I took the base cover off removed the pump & opened it up, there was loads of hair wrapped around impeller. Reassembled all working fine now.

This could be caused by a low flow issue, dirty filter, closed valve, clogged drain or impeller in some cases. Overheating (of the heater), can also be caused by a faulty heater element, or in the case where it's not really overheating, a faulty hi-limit or temp sensor. My spa pack is throwing a PSoL error. Coleman Spa Owners Manuals. 1993-1997 Coleman Spas/ Cal Cooperage Model 20/60/70 Owners Manuals 1997-2000 Coleman Spas/ Cal Cooperage 100 Series Owners Manual 2000 Colman Spas 500 Series Owners Manual 2001-2002 Coleman Spas/ Cal Cooperage 100 Series Owners Manual 2001-2002.

As a separate tip a washing machine hose with a male to male adapter the other end in a bucket works in order to test rather than keep connecting then unconnecting to spa I took the base cover off removed the pump & opened it up, there was loads of hair wrapped around impeller. Reassembled all working fine now. As a separate tip a washing machine hose with a male to male adapter the other end in a bucket works in order to test rather than keep connecting then unconnecting to spa •.

SF (not 5F) = Temperature Sensor or Thermistor HS = High Limit Sensor Heaters Set Temperature out of Sync with actual Water Temperature. Heaters Maximum Water Temperature has been Exceeded. A few reasons this occurs. • Low water flow thru heater, check: • Dirty Filter • Opened By Pass Valves • Plugged pump impeller • Dirty/Full baskets at skimmer or pump • Anything that may reduce water flow • Sensor could actually be doing its job, in a different aspect, Thermostat failure, and water is overheating in spa or pool? But anyway, your heaters fault code you asked about does not necessarily mean the sensor failed, but is only informing of a problem.

Serial Killer Found In Las Vegas. Jun 07, 2015 . FL is a flow error, you may not have enough water going over filter housing.

Jets are they open? Is your heater fitted with a pressure switch? Ansi C Balaguruswamy Free Rapidshare Search.

When on FL locate pressure switch wheel and turn all the way anti clockwise until it stops then slowly wind back until you hear a click reset in control box - you have reset pressure switch. If you have done this and still show FL or heater is not fitted with pressure switch then your LOW speed on pump maybe faulty (new pump) or heater maybe scaled up with lime scale and reducing water flow through heater - remove scale from heater, flush through and increase ANTI-SCALE Adam Miller Service Manager, Canadian Spa Company, UK Aug 07, 2010 .